Lift & Leveling Kit Installation Near Midvale, UT
Leveling kit and suspension lift installation for trucks and SUVs, with alignment included. Our shop is 5 miles from Midvale — about 8 min. We diagnose every issue before recommending any repair.
Lift & Leveling Kit Installation Near Midvale
Getting here: Head north on State Street from Midvale — it's a straight 5-mile shot into South Salt Lake with no turns required until you reach Crystal Ave on your left. Turn left and our shop is on the right. About 8 minutes in light traffic. TRAX Blue Line riders can board at Midvale Center and ride to Central Pointe station — a 3-minute walk to our door.
Midvale customers can take the TRAX Blue Line — board at Midvale Center and ride north to Central Pointe Station, then walk 3 minutes east to our shop at 144 W Crystal Ave. Drop your car in the morning, ride TRAX to work or wherever you need to be, and we'll call when the job is done. Uber and Lyft are also available from our lot throughout the day for the return trip to Midvale.
I-215 Fort Union Interchange — Cottonwood Canyon Access
4 min east of shopThe main freeway connection from Midvale to the Cottonwood Canyons. From here, Highland Drive continues south to Big Cottonwood Canyon in about 10 minutes — the eastern terrain that Midvale truck owners most often access.
Midvale Center TRAX Station — 7200 S State Street
5 miles south of shopThe most convenient Blue Line stop for Midvale customers dropping a truck for an all-day install. Board here heading north and ride to Central Pointe — 3 minutes from our shop on foot.
7200 South & State Street
4 miles south of shopThe main Midvale commercial intersection on State Street. Head north from here for about 4 miles straight — Crystal Ave will be on your left just past the 2700 South light. We're halfway down the block.
What Is Lift & Leveling Kit Installation?
A leveling kit corrects the factory front-to-rear height difference on trucks and SUVs using spacers or strut extensions — raising the front to match the rear without significantly changing ride quality. A suspension lift raises the entire vehicle by replacing or augmenting springs, shocks, and sometimes control arms, adding clearance for larger tires and off-road use. Both require a wheel alignment after installation to maintain proper handling, tire wear, and steering geometry.
Why Midvale Drivers Need Lift & Leveling Kit Installation Specialists
Midvale's central south valley location gives truck owners access to two very different terrain types: the rocky, technical Cottonwood Canyon approach roads to the east, and the Oquirrh Mountain dirt network and Tooele backcountry to the west via I-215. The kit that works for both is a 2- to 3-inch leveling setup with a quality all-terrain tire in the 275/65 to 285/70 range — enough clearance for rocky canyon approaches, enough sidewall for loose Oquirrh shale, and manageable road noise on the freeway segments between. Central Pointe TRAX makes same-day drop-off easy if you want to leave the truck and come back when the install is done.
That's why Midvale drivers bring their lift & leveling kits work to us. We diagnose the cause before recommending anything — you'll know exactly what needs to happen before any work begins.
Local tip: Midvale's dual corridor access means your AT tire choice matters — canyon rock and Oquirrh shale stress tires differently. A tire with a chunky tread block handles both terrain types better than a highway-biased all-terrain that's really just a cosmetic upgrade.
How We Handle Lift & Leveling Kit Installation for Midvale Customers
Midvale customers are 8 minutes away — the closest TRAX-accessible shop in the valley. Most jobs are done same day.
Tell Us What You're After
Let us know your vehicle, lift height or leveling goal, whether you're running new tires, and how you use the truck — off-road, daily driver, or towing.
Suspension Assessment
We inspect ball joints, tie rod ends, CV boots, and shocks before installing anything. Putting a new kit on worn components creates handling problems.
Parts & Fitment Confirmation
We verify the kit fits your exact year and configuration before starting. Some trucks have mid-year changes that affect fitment.
Installation
The kit goes in correctly — torqued to spec, hardware inspected, no shortcuts. Most leveling kits take 2–3 hours; suspension lifts take 4–8 hours depending on complexity.
Alignment & Road Test
Every lift gets an alignment. We verify steering, handling, and ride feel before the truck goes home.
Common Lift & Leveling Kit Installation Problems We See from Midvale
We diagnose before we recommend — Midvale customers know exactly what's wrong and why before any work begins.
Uneven Stance (Factory Rake)
Most trucks leave the factory nose-down to account for payload sag. A leveling kit brings the front up to match the rear for a level stance and cleaner appearance.
Insufficient Tire Clearance
Running larger off-road tires requires additional lift to prevent rubbing on body panels and suspension components during full travel.
Limited Off-Road Ground Clearance
Factory ride height limits approach, departure, and breakover angles. A suspension lift adds the clearance needed for trails, rocky terrain, and off-pavement driving.
Post-Lift Alignment Problems
Many trucks installed elsewhere come in with uneven tire wear, pulling, or steering wander from lifts that were never properly aligned after installation.
Why Midvale Drivers Choose Scott's for Lift & Leveling Kit Installation
Midvale is 5 miles from our shop. Drivers come this far because these are the things that matter — and they can't find them closer to home.
8 Minutes or One TRAX Stop
State Street north — or board the Blue Line at Midvale Center and ride to Central Pointe, a 3-minute walk from our door.
We Know I-15 Interchange Driving
Midvale's I-15/I-215 interchange is one of the tightest in the valley — hard accelerations and abrupt stops create wear patterns we see from Midvale vehicles regularly.
Diagnosis Before We Recommend Anything
We check the whole system before pointing to any specific part. You know exactly what we found and why before any work begins.
In Business Since 1990
Midvale drivers come here because we're close and because we get the diagnosis right. We've been doing this since 1990 and fix it the first time.
Lift & Leveling Kit Installation — What Midvale Customers Get
Every lift & leveling kits job for Midvale customers starts with diagnosis. We find the root cause before recommending anything — and only do the work your vehicle actually needs.
More Auto Repair Services Near Midvale
We handle the full range of mechanical repairs for Midvale drivers — same shop, same mechanic, same honest diagnosis.
Lift & Leveling Kit Installation Near Other Salt Lake Valley Cities
We serve all of the Salt Lake Valley from our South Salt Lake shop — one location, every city.
5-Star Reviews
What Our Customers Say
Real reviews from Google — 5 stars across the board
“This guy did great work on a couple of things we had done on our vehicle. All in all great work.”
“Was on my way across the country and they took me in on short notice, diagnosed and fixed my issue in a few hours. Good price too.”
Frequently Asked Questions — Lift & Leveling Kit Installation Near Midvale
Do I need an alignment after a leveling kit?
Yes, always. Even a small spacer leveling kit changes the front caster and camber angles. Driving without an alignment after installation causes uneven tire wear and affects steering feel. We include alignment with every lift and leveling kit installation.
What's the difference between a leveling kit and a lift kit?
A leveling kit raises only the front of the truck to match the rear — correcting the factory nose-down rake. It typically adds 1–2.5 inches using strut spacers or extended strut toppers. A lift kit raises the entire vehicle by modifying or replacing suspension components, adding 2–6+ inches of total height for ground clearance and larger tire fitment.
Will a leveling kit affect my ride quality?
A quality spacer leveling kit on a truck in good suspension condition typically causes minimal change. Some stiffer spacers make the ride slightly firmer. If your shocks are already worn, adding a leveling kit makes that more noticeable — which is why we inspect the suspension before installing.
How big of a lift do I need for a specific tire size?
It depends on the truck and tire size. As a general guide, most half-ton trucks need at least a 2" leveling kit to fit 33" tires without rubbing, and a 3–4" suspension lift for 35" tires. We confirm fitment for your specific vehicle and tire combination before starting any work.
Can I supply my own kit, or do you source them?
Either works. If you've already purchased a kit, bring it and we'll install it. If you'd like us to source parts, tell us your vehicle and lift goals and we'll quote options.
How long does installation take?
A leveling kit installation typically takes 2–3 hours. A suspension lift kit takes 4–8 hours depending on kit complexity and your truck's configuration. We give you a realistic timeline when we quote the work.
Is there a warranty on the repair?
Yes. Every repair we perform is backed by a 2-year parts and labor warranty. If something we installed gives you trouble within two years, bring it back and we make it right at no charge.
How does your pricing compare to dealers and chain shops?
Our labor rates are consistently below dealer rates — typically 20–40% less for the same installation. We use quality hardware and back every job with a 2-year parts and labor warranty. You get a written estimate before any work starts so there are no surprises.
Ready for Quality Auto Repair?
Contact Scott's Auto & Clutch Repair today for honest service and expert repairs.
- Free Estimates
- Competitive Pricing
- Same or Next Day Service
- 2-Year Parts & Labor Warranty
- Free Towing on Repairs Over $1,000
144 W Crystal Ave, South Salt Lake, UT 84115